Battery charging
Registering a handset
For optimal performance, charge the handset
battery for at least 16 hours before use.
To register a new handset:
1. Place the unregistered
handset in the telephone
base.
12:00AM
Place in
Charger
Quick start guide
for model LS5105
2. Press the MENU softkey on
the telephone base while in
idle mode.
Electrical outlet
not controlled by
a wall switch
Battery installation
Install the battery as shown below.
3. Press the UP and DOWN
Navkeys to highlight Register
Handset, then press the
SELECT softkey.
12:00AM
Register handset:
1. Press the tab and
slide the battery
compartment cover
downwards.
2. Insert the plug as
Press MENU in the
base. Find 'Register
Handset' in the Main
Menu. Press SELECT.
indicated. Make sure
it is plugged securely
and matches the color-
coded label inside the
battery compartment.
• Registering Handset will
appear on the telephone
base display.
Power
adapter
12:00AM
• Registration in progress...
will appear on the handset
display.
Registration
in progress...
• The registration process
may take up to 90 seconds
to complete.
When the registration process is complete, the
telephone base and handset will generate a
confirmation tone. The newly registered handset
will be assigned the next handset registration
number.
3. Place the battery
with the label THIS
SIDE UP facing
up and the wires
inside the battery
compartment.
4. Align the cover flat
against the battery
compartment, then
slide it upwards until it
clicks into place.
NOTE:
For complete feature instructions, please refer
to your user’s manual.
Charger
Charge light
IMPORTANT!
If your product is not working properly:
• Refer to the Troubleshooting section of the
user’s manual.
NOTE:
Use only the power adapter and battery supplied
with your VTech telephone.
call 1 (800) 595-9511. In Canada, go to www.
vtechcanada.com or 1 (800) 267-7377.
96-006551-020-100
issue 1
|